It is necessary to clean the spray arms regularly as hard water chemicals will clog the spray arm jets and bearings. To remove the
spray arm,
the nut to take out the washer on top of the spray arm and remove the arm. Wash the arms in
water
and use a soft brush to clean the jets. Replace them after rinsing them thoroughly.
unscrew
warm soapy
Never run the dishwasher without the filters in place.
Filter assembly
For best performance and results, the filter assembly must be cleaned.
The filter efficiently removes food particles from the wash water, allowing it to be
recirculated during the cycle. For this reason, it is a good idea to remove the larger
food particles trapped in the filter after each wash cycle by rinsing the semicircular
filter and cup under running water. To remove the filter assembly, pull on the cup
handle in the upward direction. The entire filter assembly should be cleaned at least
once a month.
To clean the coarse filter and the fine filter, use a cleaning brush. Then, reassemble
the filter parts as shown in the fi gure (left) and reinsert the entire assembly in the
dishwasher, positioning in its seat and pressing downward.
The dishwasher must never be used without the filters. Improper replacement of the
filter may reduce the performance level of the appliance and damage dishes and utensils.
WQ P8-9 325
P
8 8
Never use a spray cleaner to clean the door panel as it could damage the door lock and electrical components. Do not use abrasive
agents or paper towels because of the risk of scratching or leaving spots on the stainless steel surface.
To clean the edge around the door, you should use only a soft warm, damp
. To prevent
penetration o f water into the door lock and electrical components, do not use a spray cleaner.
Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will
scratch the finish. Some paper towels can also scratch or leave marks on the surface.
cloth
Particles can occasionall y move into the filters and the drain pump. If this occurs, the dr ain
pump used in your dishwasher is designed to automatically reverse, ejecting the item back
into the sump area or down the drain. If you have to remove an obstacle from the drain pump,
before you remove the fil ters, you should turn off the power; Then remove the small black
insert from the sump area. (You might want to remove any standing water first).
Sco op out the item that is in the sump area and causes the obstruction. Remember to rep lace
the black insert before you put the filters back in.
After every wash, leave the door slightly ajar so that
moisture and odors are not trapped inside.
Before cleaning or performing maintenance, always
remove the plug from the socket.
To clean the exterior an d rubber parts of the dishwasher,
do not use solvents or abrasive cleaning products.
Rather, use only a cloth and warm soapy water.
To remove spots or stains from the surface of the
interior, use
and a little
white vinegar, or a cleaning product made specifically
for dishwashers.
a damp clot
When you go on holiday, it is recommened that you run a
wash cycle with the dishwasher empty and then remove
the plug from the socket, turn off the water supply and
leave the door of the appliance sl ightly ajar. This will help
the seals last longer and prevent odors from forming
within the appliance.
If the appliance must be moved, try to keep it in the vertical
position.If absolutely necessary, it can be positioned on
its back.
One of the factors that cause odors to form in the
dishwasher is food that remains trapped in the seals.
Periodic cleaning with a damp sponge will prevent this
from occurring.
10
Summary of Contents for UDW601
Page 17: ...14 ...
