14 / EN
Hood / User Manual
6
Troubleshooting
Symptoms
Cause
Repairing method
During hood operation, the pulsating
letter „F” is displayed.
After 35 hours of operation the hood
indicates the need for cleaning or
replacing the grease filter.
Press and hold for about 8 sec. “-” on
the touch control. The filter should be
washed in the dishwasher or replace with
a new one.
The display shows only the symbol
“-.” (minus and dot in the right bottom
corner), the hood does not respond to
disabling.
The touch control has been locked
– this feature facilitates the hood
cleaning.
To disable the lock, press and hold for
about 10 sec the field with the symbol of
switching on.
No symbol is shown on the display, the
hood does not respond to pressing the
control fields.
The touch control is probably sus-
pended.
Disconnect the hood from the power
supply for about 15 sec. and switch it on
again.
The display shows the symbol of one of
the gears; the hood does not respond
to pressing the control fields.
The touch control is probably sus-
pended
Disconnect the hood from the power
supply for about 15 sec. and switch it on
again.
The hood turbine disconnects after 15
min of operation, the display shows
a pulsating digit i.e. “1.” (current gear
number and dot in the right bottom
corner).
The automatic time switch of the
touch control has been activated.
To deactivate the time switch, press and
hold for about 10 sec the symbol „+”or
disable the hood.
On fourth gear the digit “4” is pulsating
on the display, after 5min the gear is
changed into third.
The hood is equipped with a turbo
mode, which automatically switches
over into third gear after 5 min of
operation to save energy.
The turbo gear shall be used only with
intensive cooking.
The hood can be operated only with
use of the control panel, it does not
respond to the remote control.
The battery of the remote control is
empty or the distance is too long.
Replace the battery with a new one.
The hood has very poor vapor suction. Probably cause is dirty filters.
The grease filter must be cleaned in the
dishwasher or replace with a new one.
The carbon filter (if present) must be
replaced with a new one.
One or more light points do not
operate.
Defective halogen/ LED bulb.
The light bulb needs to be replaced
with a new, compatible with the symbol
specified in the instruction manual for
the cooker hood.
The hood generated excessive noise
and vibration.
This may be caused by an incorrect
installation of the hood to the wall
or kitchen cabinets. Not all provided
screws have been used or screws are
loosely fitted leaving clearance.
The hood must be mounted to a wall or
cabinet by using all the points provided
for by the manufacturer. After adjusting
the position of the hood horizontally and
vertically, tighten all mounting screws.
* applies to hoods with touch control.
If the recommendations above do not solve the problem, contact an authorized home appliances service entitled to repair.
Under no circumstances is the hood user entitled to independent repair. A list of service points is included in the warranty
card and the website.