Beko BEKOMAT 8, Installation And Operation Manual, Page: 21 / 28

EN
Installation and operation manual
BEKOMAT
®
8/9 21
6.2. Cleaning
The BEKOMAT
®
is cleaned with a damp (not wet) cotton or disposable cloth as well as mild, commercially available
detergent / soap.
Spray a little detergent onto the clean cotton cloth or disposable cloth and carefully wipe the component. Then dry using a clean
cloth or let it dry at room temperature. Observe all hygiene instructions applicable on the site.
NOTE Damage to device caused by improper cleaning
Cleaning with a wet cloth, hard or pointed implement or aggressive detergent can damage the
components and integrated electronic components.
• Never clean the device with a dripping wet cloth.
• Do not use aggressive detergents.
• Never clean the device with hard or pointed implements.
Cleaning
A. Clean container:
Do not press the TEST button, rather:
•
Shut off the supply line
• Carefully open the manual
condensate drain on the container
• Residual pressure flushes the
container
B. Clean sensor tube:
• Disassemble the flange on the top
side of the container (loosen hose
connection, cable connector and
flange screws, lift out flange with
electronics and sensor tube)
• Only clean the sensor tube from the
outside
• Assemble components properly
C. Clean valve:
Only loosen the screw that are not
colour-marked! Coloured screws have
been set in the factory and must not be
adjusted!
B
C
A