BEKA ZEPTO, Original Operating And Assembly Manual, Page: 43 / 56

-43- © BEKA 2019 All rights reserved!
BA
L_
ZE
PT
O_1
01
9D
E_
EN.docx
11.4.3 Operational mode of pulse-dependent lubrication duration P3
In program P3 , the lubrication duration is determined by the number of the incoming pulses of a sensor (e.g. proximity switch on a
progressive distributor). If the control does not receive a pulse signal within the monitoring time (12 minutes), it shows the error E5 in
the display and the device signals a malfunction (see chapter 15.1 “Signal displays of the control“ ).
After eliminating the cause of error, the error must be reset as described in chapter 15.2 “Resetting the error E5” .
The sensor is connected to the bushing M12x1.
Setting:
Hold down the left control key until the
current setting appears in the left
segment of the display, e.g. “ 1 ”
Press the left control key as often as
required until the desired setting is
reached.
The control saves the setting automatically;
no further confirmation is necessary.
Display 1 2 3 4 5 6 7 8 9
Lubrication duration (pulse[s]) 1 2 3 4 5 6 7 8 9
If program P3 is selected, a sensor must be connected, otherwise the device displays the error E5 after
12 minutes and signals a malfunction (see chapter 15.1 “Signal displays of the control“ ).
incoming
pulse signals
Time-dependent
cycle duration
Pulse-dependent
lubrication duration
Notice!