BEKA ZEPTO, Original Operating And Assembly Manual, Page: 41 / 56

-41- © BEKA 2019 All rights reserved!
BA
L_
ZE
PT
O_1
01
9D
E_
EN.docx
11.1 Program setting
Depending on the version, you can choose between two or four different program settings at the device.
Hold down the right control key and the
push-button for intermediate lubrication
until “ P “ appears in the left segment of
the display. The current program is
displayed in the right segment.
Press the push-button for intermediate
lubrication again briefly; the next
program number appears. Repeat
pressing the buttons until the desired
program is reached.
The control saves the setting automatically;
no further confirmation is necessary.
Program
Simple version
Device 10142862
Complex version
Device 10144013
P0 Permanent operation Permanent operation
P1
(Standard)
Operational mode of time-dependent lubrication
duration
Operational mode of time-dependent lubrication duration
P2 unavailable
Operational mode of time-dependent lubrication duration
with system pressure monitoring
P3 unavailable
Operational mode of pulse-dependent lubrication
duration
11.2 Permanent operation P0
The device is always ready-to-use in permanent operation. However, it only operates as long as a release signal is applied at PIN
3 of
the DEUTSCH plug (see chapter 8.2.1 “C
onnection diagram of DEUTSCH plug male” ).
11.3 Cycle duration
The cycle duration is always determined time-dependent in the programs P1 , P2 and P3 . It is shown in the right segment of the
display and can be set via the right control key .
Setting:
Hold down the right control key until the
current setting appears in the right
segment of the display, e.g. “ 1 ”
Press the right control key as often as
required until the desired setting is
reached.
The control saves the setting automatically;
no further confirmation is necessary.
Display 0 1 2 3 4 5 6 7 8 9
Cycle duration (h) 0,5 1 2 3 4 5 6 7 8 9