BEKA BA577E, Manual

Page: 14 / 38

14
Display Summary of function
unit5
Units of display
Selects displayed units.
1
2 : 00 : 00
Hours, minutes & seconds
12 : 00
Hours & minutes *
30 : 00
Minutes & seconds
30
Seconds
Excludes delay of optional control
outputs which is always shown in
seconds and the grand total which is
always shown in hours.
* Only available if
5et t
and
r5t dELA
,
if already entered, specify zero
seconds or seconds which are exactly
divisible by sixty.
See section 5.5.9
5Et t
Set time
When controlling an external event via
the
optional control outputs the
BA577E will time-down from the set
time to zero or time-up from zero to the
set time.
Note: Timer will only start if a non zero
value is entered for set time
5et t
.
See section 5.5.10
CYCLE5
Repeat timing cycle
Contains a sub-menu with three
sub-functions,
EnbL
,
CYCL Cnt
and
r5t dELA
.
See section 5.5.11
Cycle function enable
EnbL
Enables or disables the
cycle5
function without changing the
parameters.
See section 5.5.12
Cycle count
CYCL Cnt
Defines the number of times that the
timer cycle is repeated.
See section 5.5.13
Restart delay
r5t dELA
Defines the time delay between timer
cycles.
See section 5.5.14
AC5Et t
Access
5Et t
and
r5t dela
from
display mode.
Enables
5Et t
and
r5t dela
to be
adjusted from the display mode. Also
contains a sub-function
ACCd
which
defines a separate code to protect
access from the display mode to
5Et t
and
r5t dela
.
See section 5.5.15
Display Summary of function
uP or dn
Direction of count
Defines whether the Timer times-down
from
5Et t'
to zero or times-up from
zero to the set time
5Et t
.
See section 5.5.16
P-FAiL
Power Failure
Defines how the Timer functions when
power is restored after a power failure.
Contains three sub-functions
idle
,
Pau5E
and
continue
.
idle
Timer returns in stopped state
as if having completed a
single timing cycle displaying
Timer value when power was
lost.
Timing resumes when
reset followed by start
instructions are received.
Pau5e
Timer returns in paused state
displaying Timer value when
power
was lost. Timing
resumes when start
instruction is received.
Continue
Timer will continue without
any manual intervention.
See section 5.5.17
LoC r5Et
Local reset
Contains two sub-functions which
when enabled allow the Timer and the
grand total, which represents total
Timer run-time, to be reset to zero via
the front panel push buttons while the
Timer is in the display mode.
See section 5.5.18
Local total reset
r5Et.EnbL
When
on
is selected, Timer is reset to
zero, or
5et t
if timing-down , when the
&
and
*
buttons are operated
simultaneously for more than three
seconds in the display mode.
See section 5.5.19
Local grand total reset
CLr Gtot
When
on
is selected the grand total,
which represents total run-time, may
be reset to zero by operating the
)
and
*
buttons simultaneously for
more than 10 seconds in the display
mode.
Note: Once reset, the grand total can
not be recovered.
See section 5.5.20