BEKA BA458C, Manual

Page: 15 / 45

15
When navigating through the menus the push-
button(s) should be held until the required
screen is displayed.
Note:
Functions that are dependent on a higher level
option are automatically removed from the sub-
menu when the higher level option is not
selected. e.g. If the batch controller is
configured for a pulse input, all the calibration
functions associated with a 4/20mA input will
be automatically removed from the menus.
6.3 Default configuration
Unless otherwise requested at the time of
ordering, BA458C batch controllers will be
supplied configured as follows:
System Settings
Language English
Operator control
Both Local &
Remote.
Signal Input Open Collector
Lineariser Off
Restart Normal
Output 2 Unused
Output 3 Unused
Optional outputs 4, 5 & 6 Unused
Pulse Output Display / 1
Grand Total Cleared
Security
Config. Code 0000
Operator Code 0000
Operator Menu
Batch Sizing On
Batch Select On
History On
Config. Menu On
Operator Screens Screen 1
Batch Settings
Scale factor (Linear pulse) 000001.
Scaling (4/20mA input)
000001.
Batch D.P. 00000000.
Batch Legend No legend
Batch Limit 99999999
Batch Names Batch 1
Batch Size 00000000.
Select Batch Batch 1
CONTROL2delay 0000
CONTROL2stop 00000000.
CONTROL3delay 0000
CONTROL3stop 00000000.
Count Mode Up
Overrun Comp Off
Batch Cycles 1
Restart Delay 00 : 00 : 00
Rate Settings
Rate Scaling 000001.
Rate D.P. 00000.0
20mA Display 00100.0
Rate Legend No legend
Timebase Seconds
Rate Filter
Smoothing 2
Jump-Out 4
Flow Alarm 00000.0
Inhibit Time 0000
Clip-Off 00000.0
Default parameters may be globally restored
see section 6.4.13