Beisler 100/68, Operating Instructions Manual

Page: 54 / 162

3.3 Distance between the transport clamps and the sole of the folder
Standard and checking
There must be a certain distance between the outer edges 1 of the
folder sole and the inner edges 2 of the transport clamps. When
processing medium-weight materials the distance should amount to
approx. 1.0 to 1.5 mm.
The distance is necessary to guarantee uniform piping strips on both
sides as well as an unhindered material feed.
Caution: Risk of injury!
Switch the main switch off.
Check and adjust the transport clamps only with the sewing unit
switched off.
Attention: Risk of breakage !
Before adjusting the folder has to be correctly aligned (see chapter
“4.2 Position of the folder as to the needles and the centre knife”).
–
Push the transport carriage to the front.
–
Let the compressed air off.
–
Lower the folder.
–
Check the distance between folder sole and transport clamps.
Correction
–
Adjust the clamping arm 4 with the knurled nuts 3 and 5.
14
2 1
5 4 3