Beijing Huitianwei Technology Co., Ltd.
23
It's just a point of operation, click the button on the screen of the other three
figures, repeated fourth, fifth step operation, calibration points respectively.
It should be stressed, when adjusting one point, it may have an impact on
other points, therefore, we recommend when the four points are adjusted
again, click the " Controls" button, click on "home" key to platform homing,
repeat fourth to the sixth step operation, re round of testing to ensure the
accuracy of the distance.
When the four points have been adjusted, print a test file again, click on "SD
Card" button, click "test1.gcode" file, click to start printing, print out the three
circles observe whether the firm fit, the material is uniformly perfect circle, if so,
then the platform has been adjusted, you can print the other, if not, then return
to the first step to re-start adjusting operating platforms.
○
Refueling operation
The first step, press and hold down spout blue plastic sheet, pull out the white
securing tube (Figure 5-10);
(Figure 5-10)
