Beijing Huitianwei Technology Co., Ltd.
18
Section 5 Common Problem
○
Tuning Platform
Transfer platform to be operated knob: There are four fixed point below
the platform, the four is to control the platform level and adjust the balance
point, these four points at the bottom, it is what we need to "leveling knob"
（
Outside leveling knob is hot melt adhesive stick (Figure 5-1
）
，
this is to
prevent the transport process because knob and affect highly Platform.
Platform at the factory has been adjusted to the best state, under normal
circumstances do not need regulation.
(Figure 5-1)
○
Why you will need to adjust the platform
Z-axis coordinate print head is not going to change, coordinate platform has an
upper and lower limit, when you reach the platform uppermost limit, if the
distance from the nozzle of inappropriate words, we have to fine-tune the
height of the platform to control the distance between the platform and the
nozzle.
○ What is the correct distance from the nozzle and platforms
Between the platform and the nozzle is placed a piece of A4 paper, turn the
nozzle is moved to the top of the platform four fulcrum, parallel drag out the
paper, if you feel resistance, but it will not tear the paper, this distance is
correct. Remember that you must be a distance of four fulcrum are correct, in
order to ensure the proper platform from the nozzle.
