9A
4.2. Main Function
To select any of the pre-set functions, press the
MENU
button up to when the required one is
shown on the display. Select the function by
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the mode. Once the required mode has been selected,
press the
ENTER
button to setup or it will automatically return to the main functions without
any change after idling 8 seconds. To go back to the functions without any change press the
MENU
button. The main functions are shown below:
MENU
Focus Adjust
Self-Test
Reset
Fixture Hours
Display Inversion
Display Normal
Tilt Inversion
Tilt Normal
Pan Inversion
Pan Normal
Split Color
Normal Color
Slave mode " 2 Light Show "
Slave Mode " Normal "
Show Mode " Show 2 "
Show Mode " Show 1 "
DMX512 Address Setting
Blackout Mode " No Blackout "
Blackout Mode " Yes Blackout "
5.2. Easy Controller
The easy remote controller is used only in master/slave mode. By connecting to the 1/4”
microphone jack of the first unit, you will find that the remote control on the first unit will control
all the other units for Stand by, Strobe/Next/Strobe and Show 1/Slow/Show 2 functions.
1.
STAND BY
: To blackout all the units.
2.
FUNCTION -
STROBE/NEXT/STROBE
Under SHOW 1 and SHOW 2 mode, the units will strobe in three different ways:
a) Strobe in different gobos and colors.
b) Synchronous strobe in white color.
c) Two-light strobe in white color.
Under SLOW mode, press FUNCTION button to choose desired
color and gobo. It will change ten colors and then change one
gobo.
3.
MODE -
SHOW 1/SLOW/SHOW 2
When the LED is off, it is in SHOW 1 mode, and blinking in SHOW
2 mode. The unit’s movement- Pan/Tilt & Gobo/Color is sound
activated. If the LED on, it is in SLOW mode, Pan/Tilt is sound
activated but Gobo/Color wheel are static, controlled by Next
button.
5.3. Universal DMX Controller
If you use a universal DMX controller to control the units, you have to set DMX address from 1
to 512 channel so that the units can receive DMX signal.
Press the
MENU
button up to when the
is shown on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX512 address.
Once the address has been selected, press and keep
ENTER
button pressed up to when the
display stops blinking or storing automatically 8 seconds later. To go back to the functions
without any change press the
MENU
button again.
Please refer to the following diagram
to address your DMX512 channel for the first 4 units.
