5A
2. Technical Specification
Power supply
- AC 120V~60Hz or 230V/240V/250V 50/60Hz
Lamp
- Discharge lamp MSD 250W GY9.5
Optical system
- Standard 13° focused beam angle.
- Focus adjustable by DMX control
Shutter/Dimmer
- Blackout, 0~100 smooth dimming and strobe speed variable(1~10 flashes per second).
Gobo wheel
- Independent gobo wheel with 7 gobos plus open, gobos are interchangeable: 4 metal
gobos, 2 glass gobos, and 1 effect gobo. 3 additional metal gobos and 2 effect gobos are
included.
- Gobo wheel rotates with variable speed. Shaking effect included.
Color wheel
- Independent color wheel with 9 dichroic mirrors plus white.
- Color wheel rotates with variable speed, giving rainbow effect.
Prism -
3-facet prism rotates in both directions at variable speeds
Movement
- Pan: 540° in 2.8 second.
- Tilt: 270° in 1.6 second.
DMX Channels
- Standard DMX512 signal addressing and can be controlled by any universal DMX
controller.
Channel 1 = Pan motion
Channel 9 = Gobo
Channel 2 = Tilt motion
Channel 10 = Gobo Rotation
Channel 3 =Pan/Tilt Speed select
Channel 11 = Prism
Channel 4 = Dimmer
Channel 12 = Prism Rotation
Channel 5 = Shutter
/
Shaking
Channel 13 = Focus
Channel 6 = Color
Channel 14 = Pre-programmed Show Pattern
Channel 7 = No Function
Channel 15 = Pre-programmed Beam Pattern
Channel 8 = Reset
Channel 16 = Reset
Dimension:
360mm x 397mm x 503mm (L x W x H)
Weight:
26 kg
6. Troubleshooting
Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:
A. The unit does not work, no light and the fan does not work
1. Check the connect power and main fuse.
2. Measure the mains voltage on the main connector.
3. Check the power on LED.
B. Not responding to DMX controller
1. DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
2. If the DMX LED is on and no response to the channel, check the address settings and
DMX polarity.
3. If you have intermittent DMX signal problems, check the pins on connectors or on PCB of
the unit or the previous one.
4. Try to use another DMX controller.
5. Check in the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.
C. Some units don’t respond to the easy controller
1. You may have a break in the DMX cabling. Check the LED for the response of the master/
slave mode signal.
2. Wrong DMX address in the unit. Set the proper address.
D. No response to the sound
1. Check the unit that is not receiving DMX signal.
2. Check microphone to see if it is good by tapping the microphone
E. One of the channels is not working well
1. The stepper motor might be damaged or the cable connected to the PCB is broken.
2. The motor’s drive IC on the PCB might be out of condition.
F. The lamp is cutting out intermittently
1. The lamp is not working well. Check the main voltage either too high or too low.
Internal temperature may be too high. Check and if necessary replace the fan on the head.
