3.02 - Set Up and Assembly
Notice to dealer:
Pre-Delivery set up and service including lubrication are the
responsibility of the authorized dealer. It is up to him to assure that the machine is in
perfect condition and ready to be used. It is his responsibility to ensure that the
customer is aware of all safety aspects and operational procedures for the spreader. He
must also fill out the Pre-Delivery Checklist
3
prior to delivering the spreader.
CAUTION: Stand clear of bands when cutting as they could be under sufficient
tension to cause them to fly loose. Take care in removing bands and wire, as they
often have extremely sharp edges and cut very easily.
Note: All hardware needed for assembly will be found in the crate and the hardware bag
of the machine. Assembly will be easier if all parts are loosely assembled before
tightening the hardware.
To assemble the pendular spreader proceed as follows:
1. Slide the spout ring over the discharge chute and secure them to the gearbox using
the M10x45 bolts, Ø10 lock washers and M10 nuts
(see #1, fig. 3)
. Note: The
M10x45 bolt on the top hole does not require a nut on the other side as it screws
directly into the gearbox housing.
2. Attach the left and right protection attachment plates
(see #2, fig. 3)
to the “U”
shaped protection
(see #3, fig. 3)
using the M8x45 bolts, Ø8 washers and M8 nuts.
Make sure to assemble the plates with the bent ends facing upwards and outwards.
O
PERATION
12
BEFCO
T
URBO
-H
OP
O
PERATOR
’
S
M
ANUAL
3
See Chapter 7 - Pre-Delivery Checklist.
1
4
3
Fig. 3 - Spout and guard assembly.
2
