USER MANUAL – MODELS 6002NA/V1/V2/ & 7002xx
QUESTIONS? EMAIL US AT [email protected] OR CALL 401-404-5250
WE ARE HERE TO HELP – PLEASE CALL US FOR ADVICE!
Revision 1.6 www.bedjet.com P a g e | 16
10)
If using the AirComforter, please consult the instructions
in the AirComforter package for installation of the Air
Nozzle into the AirComforter sheet.
If you are using your
own sheets, cover the Air Nozzle with your sheets or
comforter. The Air Nozzle must be covered by a sheet or
comforter in order to distribute the air throughout the bed.
Twin sheet clamps are located on Mattress Mount to hold
your sheets in place over the nozzle so they are not pulled
off easily when turning over in bed. If bedding sheets are
not typically tucked in around the nozzle, the sheet clamps are highly recommended to be
used.
11) Plug BedJet in AC power outlet (do not use power strip)
and switch on. Power switch is located directly below
power cord. BedJet makes single beep on successful
power ON, and the remote control can now be used.
12) The Remote Control should already be synchronized with
BedJet on delivery. However, if pressing remote control
center buttons does not activate BedJet after power ON,
try synchronizing the Remote Control per instructions on
page 11. If still not working, replace the battery.
13) Familiarize yourself with turning on and off the various operating modes while the Status
Display of BedJet is visible before the BedJet is pushed under the Bed.
14) The ideal BedJet final installation location is under the bed. This product is designed to be
an extension of your bed and has been electrically
approved as safe for this installation. The BedJet requires
7 inches clearance and will fit under nearly all beds with
standard frames. Some bedframes with low hanging side
rails may look like they cannot fit the BedJet underneath,
but this is just the side rail and the under mattress area
may still have 7 inches height clearance. In these cases,
the bed frame may be lifted up and the BedJet placed
underneath. As long as the mattress or frame does not rest on the BedJet and the 3”
hose can clear the low side rail, the installation is acceptable.
15) When installing under the bed, adjust the location of the BedJet exhaust port to be as
close as possible to the Air Nozzle. Best location is for the exhaust port to be directly
under the Air Nozzle so that it can be reached with only a single 90 degree bend in hose.
The best setup will minimize the length of Air Hose and minimize the number of bends.
