21 of 30
IF YOU DID NOT PURCHASE THIS OPTION, PLEASE GO TO STEP 14.
The wires need to be feed through the full length notch on the RIGHT CABINET VERTICAL and out of
the baseboard notch. Finally, the quick connections will be made to the Transformer. Simply follow
the steps below and refer to the diagrams.
Figure B
a.
First, route the 60 inch long wire (pre-installed at the Touch Pad ON YOUR HEADBOARD)
through the smaller notch on the Cabinet Vertical and run this wire all the way into the Header
and plug the male end into the female end on the Transformer. (
Figure C
).
b.
Then, route the long power cord in the notch on the Cabinet Vertical gently pushing it as far
in as it will allow. Make sure the female end is toward the top of the bed and the male end
(normal plug end) is at the bottom end and through the baseboard notch (
Figure B
).
c.
Next, connect the female end of the long extension cord to the male end of the wire exiting
the Transformer (
Figure C
).
Summary of Contents for ECONOMY MELAMINE MURPHY BED
Page 30: ...30 of 30 APPENDIX A ...