Loader arm
Type: WLA60
Version: 1
July 2019
Page 8 van 23
2.
Safety
2.1.
General
No modifications must be made to the loader arm.
The user is responsible for making sure that the correct loader and adapter
are used (see chapter
Fout! Verwijzingsbron niet gevonden.
). The following
re important points in this regard:
The maximum pressure and number of revolutions (oil flow) must not be
exceeded. Excess pressure and excess revving can damage the machine and
cause injury.
The tool carrier must be strong and stable enough to absorb the forces and
moments exerted by the loader arm safely and under all circumstances.
2.2.
In use
Consult the tool carrier manual for the noise rating. Because this is
considerably louder than the loader arm itself, the noise load of the tool
carrier determines the rating.
The machinery must only be used for the activities for which it is designed.
Persons or animals who are present in or who approach the danger zone must
be stopped immediately and the weed brush must be switched off.
If passers by disrupt the work too much, the operator can consider
temporarily cordoning off the site.
If the loader arm starts to make a different sound and/or starts to vibrate,
work must stop immediately and the weed brush has to be switched off. Work
can only continue after the source of the noise has been identified and
resolved.
Always complete inspection and maintenance jobs.
The machinery must not be used for any other purposes during inspection and
maintenance.
The hydraulic feed to the loader arm must be disconnected during inspection,
maintenance or cleaning to prevent accidental operation.
Always comply with local work regulations and safety rules.
If the machinery is used in the dark, use sufficient lighting (approx. 50 lux at
the work site).
