Beckhoff CP39 Series, Manual

Page: 15 / 52

Product overview
CP39xx 15 Version: 3.1
3.3 CP39xx-0010 interface description
In the basic configuration the CP39xx-0010 contains the following interfaces:
• Power supply (X101)
• CP-Link 4 input (X102)
The interfaces are located at the back of the Control Panel at the connection block and point downwards.
The interfaces are freely accessible (see Fig. 9).
Fig. 9: CP39xx-0010_connection block
If you have ordered the Control Panel with Beckhoff mounting arm adapter, the connections are located
inside the adapter. You must first gain access to the interfaces. The procedure is the same, regardless of
whether you have ordered the mounting arm adapter with upwards or downwards orientation. The procedure
is shown as an example for the mounting arm adapter with downwards orientation. Follow the steps below,
as shown in Figure 10:
1. Insert a flat-blade screwdriver in the recesses on the underside of the mounting arm adapter (section A).
2. Bend the cover slightly outwards so that the latching lugs on the cover release the cover to allow it to be
removed.
3. Carefully release the latching lugs (see marking in section A) using a flat-blade screwdriver as a lever.
4. Slide the cover upwards off the mounting arm adapter (section B).
ð
You now have access to the interfaces (section C).
5. Then push the cover back onto the mounting arm adapter from top to bottom until the latching lugs snap
back into place.
A B C
Fig. 10: CP39xx-0010_access to interfaces