Beckhoff AA3000, Operating Instructions Manual

Page: 60 / 67

Fault correction
60 ─── Version: 1.0 AA3000
Number Cause Solution
13 Short-circuit in the voltage supply cable for the
holding brake [+] Replace defective cable, then measure and
check
14 Inadequate power supply of the holding brake [+] Check the settings in the configuration and
read out the electronic identification plate of
the motor again
15 Short circuit or earth leakage in the motor Replace defective motor, then measure and
check
16 Insufficient power supply Check the settings in the configuration and
read out the electronic identification plate of
the motor again
17 Interruption or crushing in the feedback line Check cables for wire break or crushing. Re-
place defective cables, then measure and
check.
18 Feedback connector not fitted correctly Check the position of the feedback connector
Loose fit of the feedback connector or no contact of
the plug contacts with the power socket of the mo-
tor. Check the connector assembly. Contact Beck-
hoff Service if necessary.
19 Cooling water pipes and/or water connections
leaky or defective Determine leakage and seal
(if necessary)