Attention
•
Do not let any objects fall onto the control unit.
•
If a display is present, protect it against being scratched by hard ob-
jects (e.g. rings, fingernails, wristwatches)
•
Wait until the control unit has adjusted to ambient temperature be-
fore connecting the control unit to the mains adapter. Condensation
that could lead to a short circuit can be caused inside the control unit
by large differences in temperature and air humidity.
Intended use
The B-Tronic CentralControl may only be used for the operation of suitable drives and
control units with bidirectional KNX radio and with the Centronic I and II range of con-
trols. You can operate a group, or multiple groups, of devices with this controller.
•
Please note that radio-controlled systems may not be used in areas with a high risk
of interference (e.g. hospitals, airports).
•
The remote control is intended solely for use with equipment and systems in which
malfunctions in the transmitter or receiver would not pose any risk to persons, an-
imals or property, or which contain safety devices to eliminate such risks.
•
The operator is not protected from interference from other telecommunications
systems and terminal equipment (e.g. even from radio-controlled systems which
are properly operated in the same frequency range).
•
Only connect radio receivers to devices and systems approved by the manufac-
turer.
•
Ensure that the control unit is not installed or operated close to metal
surfaces or magnetic fields.
•
Radio-controlled systems transmitting on the same frequency may
cause reception interference.
•
Note that the range of the radio signal is limited by legislation as well
as by design.
5
