21
EN
Built-in Gas Hob | Encimera Vitrocerámica Gas | Placa Vitro Gás
• Ensure that the gas pipe and electrical cable are installed in such a
way that they do not touch any parts of the appliance which may
become hot.
• Gas pipe or connector shouldn’t be bent or blocked by any other
appliances.
• Check the dimensions of the appliance as well as the dimensions of
the gap to be cut in the kitchen unit.
• The panels located above the work surface, directly next to the
appliance, must be made of non-flammable material. Both the
strati-fied surfacing and the glue used to secure it should be heat
resistant, to prevent deterioration.
• Turn on appliance tap and light each burners. Check for a clear
blue flame without yellow tipping. If the burners show any
abnormalities check the following:
- Burner lid on correctly
- Flame spreader positioned correctly
- Burner vertically aligned with injector nipple
• A full operational test and a test for possible leakages must be
carried out by the fitter after installation.
• The flexible hose shall be fitted in such a way that it cannot come
into contact with a moveable part of the housing unit and does not
pass through any space susceptible of becoming congested.
• Grease cranes produced at the factory to meet the requirement of
all life hob.
AF Manual Placa Vitro Gás BECKEN BGH4446.indd 21
AF Manual Placa Vitro Gás BECKEN BGH4446.indd 21
21/08/2020 17:42
21/08/2020 17:42
