BEBE CONFORT MiloFix 8536712210, Manual

Page: 40 / 94

42
IMPORTANT:
In ISOFIX use the fitting clips for lower anchorage
to the vehicle is not sufficient. It is essential to fix
the “Top Tether” to the upper anchorage point
recommended by the car manufacturer.
Fitting the MiloFix seat with additional tethers using
the vehicle’s ISOFIX additional anchorage points. The
ISOFIX anchors have been developed to obtain a safe
and easy fixation of the child safety systems inside
the car. Not all cars are equipped with these anchors
although they are standard on more recent models.
Consult the attached list of cars for which the car
seat can be installed correctly (you can also consult
additional updates of this list on the website www.
bebeconfort.com).
• In rear-facing position (GR0+), this product must
not be installed to places equipped with a frontal
air bag. You might be able to deactivate it (see
your car manual). In this case, if you can deactivate
the air bag, you can use the car seat on the front
seat.
• In forward facing position (GR1), the seat must
be placed on the car rear seat or exceptionally on
the front seat in accordance with the legislation in
force in the country of use (In France: in accordance
with the conditions stipulated in decree n° 91-1321
du 27-12-1991). If you use the MiloFix on the front
seat, it should be possible to deactivate the airbag
of the seat in question or move the passenger
seat back to a maximum (Please consult your car
manual).
• When installing the seat in the rear-facing position,
the belt of the top tether can turn one quarter
turn according to the position of the anchorage
point. This does not impair the proper operation
of the product.
• When installing the car seat, it is necessary to
remove the headrest in order to put the top tether
through correctly.
• Warning: when installing the car seat, spaces
between the base of the car seat and the vehicle
seat are possible depending on the position of the
anchorage points within the vehicle.
• It is essential that the car seat be replaced after
an accident.
• The user must always check that any luggage and
other objects likely to cause injury to the occupant
of the car seat in the case of impact are properly
secured.
• The rigid parts and the plastic sections of a child
restraint device should be positioned and installed
in such a way that they cannot, when the vehicle
is being used under normal conditions, become
trapped under a moving seat or in the vehicle door.
• Never modify the construction or the materials of
the car seat and the seat belt without consulting
the manufacturer.
• Do not use the child restraint device without
the cover. Do not replace the seat cover with
a cover other than that recommended by the
manufacturer, because it will have a direct effect
on the functioning of the child restraint.
• This child restraint is effective only if the
instructions for use are respected.
• Always fasten the child restraint even when the
child is not sitting in it.
• Never place heavy objects on the rear parcel shelf,
to avoid the danger of projectiles in the event of
an accident.
• Always check that no part of the seat or the
harness is trapped under a seat or in the vehicle
door.
• Folding seats must always be locked in place.
• After purchasing, install the seat in your vehicle.
If you encounter any installation problems due to
the length of the vehicle seat belt, contact your
distributor immediately.
EN