14
15
STEP 3
setting up two bases
Connecting straps are secured to the base frame upon delivery.
With the bases in their desired location, slightly loosen both legs to allow the strap to fit on the leg bolt,
between the leg washer and frame.
Slide side (a) of the connecting strap onto leg bolt. Swing the strap and connect side (b) to the leg bolt. Secure
the strap by shifting to the left.
Re-tighten legs.
Do not over tighten.
Use the remaining strap and repeat on other end of the base.
If a split setup is being installed, plastic connecting straps are provided (one per base) to secure the bases
together. Use both straps to secure the head and foot portions together.
a
b
STEP 1
STEP 2
STEP 4
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
syncing two bases
Unplug base from power source.
Disconnect the power-down box cable from each
control box. Make note where the cable was plugged in.
Connect the male end of the sync cord to each control
box.Insert it into the same port that you disconnected
the control box from in Step 2.
If simultaneous operation of two bases is desired, use the SmartSync™ Cord
to connect the electronics of both bases together.
Connect each power-down box male connection to the
sync cord female connection (Refer to the illustration
below).
Plug base back into the power source.
Check to ensure all cords are securely attached. Both
remotes will now operate both bases simultaneously (If
the remotes become unpaired, see page).
MUL
TIFUNCTION
6
RESET
PAIRING LED
7
MUL
TIFUNCTION
6
RESET
PAIRING LED
7
Sync Cord
Splitter
Splitter
Control Box
Control Box
Power down box
Power down box