12
13
emergency power down box
Store the power down box in a convenient location for emergency use.
(2) 9 Volt batteries are required to operate the power down feature and are NOT included.
Locate the Power Down Box under the base.
FOR EMERGENCY USE ONLY.
In the event that the base is stuck in an articulated position during a power outage-
the Power Down Box will return the base to a flat position.
The Power Down Box can only be used to bring the base to a flat position.
It will not bring the base to a flat position when the base is connected to a working power source.
Press and hold the button until the base is flat.
Note: The button can be pressed at any time during the loss of power to bring the base flat.
STEP 1
STEP 2
pair remote
The original remote that comes in the box is already paired to the bed base. No further action is required.
In the event that the remote is not paired with the base, follow the steps below.
If the Power Down Box is not available :
•
Remove back cover of the remote, locate the rubber button in the center of the back.
•
On the control box located underneath the bed, double click the RESET button, light will illuminate.
•
Press and hold the back rubber button on the remote. The button will begin to flash then become a
continuous solid light for 1 to 2 seconds and then turn off.
•
Once the remote is paired, replace back cover of the remote and test base functionality.
Remove back cover from remote
control. Remove and replace
batteries.
Press and hold button on the back
of the remote. The light will begin
to flash then become a continuous
solid light.
Both lights on the Power Down Box
and the Remote will be continuous,
then simultaneously turn off.
Replace back cover of the remote.
The remote is now paired with the
base.
Double click the button on the
Power Down Box (this will not
cause the base to move). The
light will illuminate.
STEP 1
STEP 2
STEP 3
STEP 4