6
7
installation guide
To sync two bases with the SmartSync™
cord: see detailed instructions on page 14
Uncoil the Power Down Box from the frame and install
(2) 9 Volt batteries - optional, not included.
Place box on the ground.
Ensure that it is easily accessible when the base is
turned to its upright position. For power down box
operating instructions see page .
Place the bed base box in a desired location with the
bottom of the box facing up.
Remove the binding straps and packing materials, making
sure not to puncture the box with any sharp objects.
Remove the bed base from the box keeping the
bottom of the base facing upwards for easier access to
the beds components
STEP 1
To install headboard brackets:
See detailed instructions on page 10
To install the legs, thread the washer over the bolt of the
leg with the recessed side facing the leg, and tighten by
hand.
Do not over tighten.
Uncoil input cord (connected to control box’s power
port) and plug into Power Supply.
Always use two people when setting up the base
installation guide
Ensure batteries are correctly installed in the back of
the remote.
Quickly test functions to verify proper setup before
placing mattress on base. Press FLAT to return the
base to a flat position.
Uncoil the Power Cord and connect to the Power Supply.
Place Power Supply on the ground and extend from
the base.
Ensure that the Power
Supply and all attached
cords are directed
toward the desired
surge protector.
Carefully flip the base over on to its legs.
Important: Two people are required to move the bed
base. Do not drag across the floor. Do not rest frame
on its side, excessive pressure may damage the legs.
Plug the base into a power source. A surge protector is
strongly recommended.
STEP 7
Always use two people when setting up the base
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 9
STEP 8
STEP 10
Basic setup is now complete!
Place the mattress on the
base.
Select Beautyrest® mattresses*
are compatible with the
mattress retainer attachment
panel installed on the
SmartMotion™ bases
*If the mattress is not
compatible with the
attachment panel, a
mattress retainer bar is
available for purchase at:
1-888-550-3746
WARNING
Always unplug the base from the electrical outlet before servicing any
part of the base. To reduce risk of electric shock, unplug the base before
cleaning. To safely disconnect, ensure the base is in a flat position with all
motors off, and unplug from power source.