28
9 INCH CHIPPER
SERVICE & MAINTENANCE
WARNING
BEFORE INSPECTING OR SERVICING ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE, DISENGAGE THE
HYDRAULICS, OPEN SHIELD AND MAKE SURE ALL MOVING PARTS HAVE COME TO A COMPLETE STOP.
28
9 INCH CHIPPER
ENGLISH
SERVICE & MAINTENANCE
5.17 LUBRICATION
Polyurea and lithium-based greases are not
compatible. Mixing the two grease types may lead to
premature failure.
WARNING
Lubricate the machine periodically with a lithium-based
grease. Extreme working conditions will require more
frequent greasing.
Grease the following points every 50-100 hours of
operating time:
●
Two bearings on the rotor shaft.
●
Two bearings on the hydraulic feed roller.
●
One bushing on the belt engagement pedal pivot.
●
One grease zerk on idler pivot.
●
One grease zerk on discharge chute.
Do not over grease bearings. Overfilling can lead to
excessive heat and/or unseating of the seals. Add
grease slowly and under light pressure. Whenever
possible, rotate bearing slowly while lubricating.
NOTE
Rotor Shaft
Hydraulic Feed Roller
Belt Engagement Pedal Pivot
Idler Pivot
Discharge Tube
50
h
50
h
50
h
50
h
Visit
https://qrco.de/CBCGreaseZerks
to learn
how to properly locate grease points and grease
your Crary Bear Cat machine for maintenance.
