7
9 INCH CHIPPER
ENGLISH
ASSEMBLY
Do not operate this unit without the chipper chute
correctly installed. Rotating cutting blades can cause
serious personal injury.
WARNING
1. Use a support or hoist to hold the chipper chute in place on the hydraulic feed.
2. Attach the chute support (1) to the rear end of the trailer using one 3/8" × 1-1/4” bolt (2) and nylock nut (3). Torque
to 35 ft-lbs. Refer to Figure 2.3 for proper positioning of the weldment. Attach the other end of the chute support (1)
to the chute (4) using existing hardware.
3. Attach the chipper chute (4) to the hydraulic feed using eight 3/8" × 1-1/4” carriage bolts (5) and nylock nuts (6).
Use three bolts on each side and two on the bottom. Install clamp (7) for wire harness as shown in Figure 2.3. If
feed roller is obstructing the top bolt holes, it may be necessary to use the hydraulic jack to raise the feed roller in
order to insert the top bolts. Before inserting the top side bolts to mount the chute, it is important to raise the feed
roller high enough to engage the locking mechanism. See Section 5.10 for instructions on how to use the hydraulic
jack to lift and secure the feed roller.
4. Connect the wire harness coming from the feed chute (4) to the connector that is located underneath the feed
chute (4).
In tropical regions, areas of high humidity or rainfall
amounts, dielectric grease may be added to wire
harness connectors to provide corrosion resistance.
NOTE
2.4 ATTACH CHUTE AND SUPPORT
Figure 2.3, Attaching the Chute Support
1
3
2
4
5
6
7
