BEAMEX CENTRICAL, User Manual

Page: 27 / 61

General - Installing and Uninstalling Pressure Measurement Modules 21
A
DDING A
P
RESSURE
M
EASUREMENT
M
ODULE
MC6 Workstation Host Module automatically identifies all pressure modules
connected to it based on their programmable ID numbers (seen in MC6 Work-
station's User Interface). When you add a pressure measurement module to the
CENTRiCAL, the new module should have a unique number. This is normally
pre-set by Beamex. If your MC6 Workstation has problems locating the new
pressure measurement module, please contact Beamex. Contact info is on this
manual's prepages.
The Pressure Measurement Module communicates with the MC6 Workstation
Host Module via a flat data cable. MC6 Workstation is able to communicate with
ten Pressure Measurement Modules (the cable has 10 connectors in series).
To connect the communication cable to the Pressure Measurement Module,
push the cable connector into the respective connector in the Pressure Meas-
urement Module. The connectors lock together with a “click”.
After installation, switch on the MC6 Workstation Host Module and check the
electrical function of the new pressure module by selecting it from the calibrator.