Beam RST825 SatRADIO, User And Installation Manual

Page: 7 / 30

Page 7 of 30
Exposure to Radio Frequency Signals
Your wireless mobile telephone is a low power radio transmitter and receiver. When it is ON,
it receives and also sends out radio frequency (RF) signals.
International agencies have set standards and recommendations for the protection of public
exposure to RF electromagnetic energy.
•
International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1996
•
Verband Deutscher Elektrotechniker (VDE) DIN-0848
•
United States Federal Commission, Radio Frequency Exposure Guidelines
(1996)
•
National Radiological Protection Board of the United Kingdom, GS 11, 1988
•
American National Standards Institute (ANSI) IEEE. C95. 1-1992
These standards are based on extensive scientific review. For example, over 120 scientists,
engineers, and physicians from universities, government health agencies, and industry
reviewed the available body of research to develop the updated ANSI standard.
Your RST825 utilises the Iridium L-Band satellite Transceiver, which is a low power radio
transmitter and receiver. When it is ON, it receives and sends out radio frequency (RF)
signals.
The SatRADIO Portable system contains a Li-Ion battery unit with high energy density. Do
not disassemble, puncture, throw, drop, crush, bend, or modify this battery unit. Do not
charge the battery while on an airplane.
Store the system in a cool and dry area.
It is important to monitor the heat inside the unit in the event that the case lid is closed during
operation.
Do not obstruct the main panel vent holes, or to the rear of the panel, as this may cause
overheating.
Do not submerge the system in water.
Do not place foreign metal objects or debris in the system. If debris falls into the system,
please return to factory for service.
Warning:
Do not open equipment. There are no user-serviceable parts inside.
If a DC power supply is to be used, its output must comply with the Safety
Extra Low Voltage (SELV) requirements of IEC60950.
All connectors except the Line and Accessory sockets must only be connected
to equipment ports which comply with the Safety Extra Low Voltage (SELV)
requirements of IEC60950.