Page 12 of 30
RST825 Connector Overview
Connecting the Antenna Cable
Plug the antenna cable into the TNC antenna jack located on the front right side of the
RST825 case. Ensure that the specified cable being used does not exceed the Iridium
maximum-loss rating of 3dB to ensure maximum performance of the terminal. Refer to your
Service Provider for full details or to purchase and approved cable if using a cable other than
the magnetic mount antenna included.
Connecting the Power Cable (if required)
Make sure the AC power switch supplying the RST825 is
OFF
. Plug in power cable into the
2-pin power socket located on front left side of RST825 case. Only use plug pack provided.
Connecting to the Data Port (if required)
Connect a PC/Laptop to the Data port to make dial-up modem calls. The Iridium data speed
is 2400bps, and can be as high as 10kbytes if using Direct Internet compression. A data call
cannot be made at the same time as a voice call.
Connecting to the Config Port (if required)
Connect a PC/Laptop to the Log port to use the Beam Management System. The
Config
Port
should only be used for configuration and control of the terminal equipment.
Note:
The Configuration port is
not
for standard Iridium Data Services,
use the Data Port for data services.
Power
Input
Iridium
Antenna
Connector
Data Port
Config Port
Two-way
Antenna
Connector
Summary of Contents for RST825 SatRADIO
Page 29: ......
Page 30: ...Page 30 of 30 ...
