2
PLEASE READ & SAVE ALL INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT
WARNING - to reduce the risk of fire, electrical shock or injury to persons or property, please follow the
guideline below for safe use and installation.
This remote controller is designed to control your ceiling fan speed, and lamp. There are 3 main functions, FAN
AUTO, MANUAL, and TIMER functions, which will allow the flexibility to control the fan speed and on/off, and
light functions by incorporating timer and thermal sensor to operate the fan and light.
INSTALLATION REQUIREMENTS:
•
Must be installed by a Licensed Electrician
•
Do not exceed rated power input specification.
•
Suitability for use “indoors”.
•
This ceiling fan remote controller is only suitable for controlling the fan motor and the light
kit associated with the ceiling fan only. Any other use would consider as misuse and
warranty is void.
•
Do not install fan remote controller with existing fan wall controller. Remove existing wall
controller and replace with a double pole wall switch, to power the fan remote controller.
•
Do not use a solid state dimmer with this ceiling fan remote controller.
INSTALLATION PREPARATION:
Before carrying out the installation the following must be considered.
-
4 x AAA 1.5V (size) Batteries are required to operate the remote controller. Remove the battery cover
from the back of the remote and insert 4 x AAA. Ensure the polarities are correct as shown in the
battery compartment, and that the batteries are all fresh batteries. (Batteries not included)
Fig.1 Battery compartment
-
The remote (transmitter) and receiver must be configured so that communication between each other is
paired up. This is achieved by setting the DIP Switch on the receiver and remote on the same setting.
Note: The DIP switch assembly has 4 switches which can be setup to 16 different transmitting code
combinations. This is practical when there is more than 1 remote/receiver pair operating locally or in the
same room.
