6/8
RED-GREEN
RED-GREEN
RED
During setup the LED
continues to flash
quickly red-green.
The power supply is too weak.
High intensity light (discharge
lamps) disturbs the sensor.
During setup the LED
continues to flash
slowly red-green.
The sensor does not
respond to the remote
control.
The batteries in the remote
control are not installed properly
or dead.
The remote control is badly
pointed.
The sensor is not powered.
The sensor requires an access
code.
Verify or replace the batteries.
Make sure the power supply is
stable.
Change the position of the lamps.
Point the remote control towards
the sensor.
Check the power supply of the
sensor.
The sensor does not
unlock, even after
entering the access
code.
You have to enter a code or the
wrong code was entered.
(Maybe it was changed?).
Cut and restore power supply.
No code is required to unlock
during the first minute after
powering.
New access code: + + new code
Delete access code: + + 0000
LED
SYMPTOMS
POSSIBLE CAUSES
CORRECTIVE ACTION
TROUBLESHOOTING
RED-GREEN
Internal problem
The red and green
LED are permanently
on.
The sensor is defect and has to be
replaced.
The IR sensor does
not react.
The IR power emission is too
low according to the mounting
height.
Launch a new setup.
Make sure to step out of the
detection field before.
RED
OFF
