Page 18
Gas and Oil Fill-Up
Service the engine with gasoline and oil as instructed in the engine manual packed with your log splitter. Read the
instructions carefully.
WARNING!
Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are
explosive. Never fuel the machine indoors or while the engine is hot or running.
NOTE:
Your log splitter is
shipped with motor oil in the engine
. You
MUST
check the oil level before operating. Be careful not
to overfill. Gasoline can be added to the engine when the log splitter is in either the horizontal or vertical position. However, it
may be easier when the splitter is in the vertical position.
Tire Pressure
The max recommended operating pressure is 30 psi. Under any circumstances do not exceed the manufacturer’s
recommended psi. Maintain equal pressure on all tires.
WARNING!
Excessive pressure when seating beads may cause tire/rim assembly to burst with force sufficient to
cause serious injury.
Preparing the Log Splitter
1. Lubricate the beam area (where the splitting wedge will slide) with engine oil. Do not use grease. See FIGURE 15.
2. Fill hydraulic oil before your initial use.
NOTE:
The log splitter is shipped without hydraulic fluid in the reservoir. Use the hydraulic oil your dealer provides, or
buy the hydraulic oil recommended below.
ASSEMBLY & SET-UP INSTRUCTIONS
SET-UP
(FIGURE 15)
Page 21
Summary of Contents for AGRI EASE BE-LS22TL6505GC
Page 2: ......