14
Eliminating blockages
AirMAB 5000
GB
Drilling with twist drills
When drilling with twist drills, proceed as
follows:
Push twist drills with MK taper into the
spindle taper (3) of the machine from
below.
Push twist drills with straight shank
into the drill chuck after fitting the drill
chuck.
Place the machine at the working loca-
tion, align it and switch on the mag-
netic clamps.
NOTE
Under excessive pressure, the drill
►
can wear out and the machine can be
overloaded.
Make sure that swarf is removed
►
regularly. With larger drilling depths,
break the chip.
Eliminating blockages
WARNING
Danger of cut injuries from broken
tool parts or swarf .
Put protective gloves on before start-
►
ing work.
Blockages caused by a broken tool:
Switch the machine off using the mo-
tor switch. Leave the magnetic clamp
switched on.
Disconnect the compressed air supply
Use the handle to move the machine
slide to the upper position.
Replace defective tool. Remove swarf.
Other blockages:
Switch the machine off using the mo-
tor switch. Leave the magnetic clamp
switched on.
Disconnect the compressed air supply
Use the handle to move the machine
slide to the upper position.
Remove swarf and check tool.
WARNING
Risk of injury from motor starting
unintentionally!
Pay attention to the following safety
notes to avoid danger from motor starting
unintentionally:
To completely stop the motor:
►
Move the motor switch to the OFF
position.
Disconnect the compressed air sup-
ply.
