GB.10-V2
CRANKING VOLTS
××.××V LOW
«ENTER» to perform the charging system test.
CRANKING VOLTS LOW
The cranking voltage is
below
normal
limits,
troubleshoot the starter
with manufacturers recommended procedure.
CRANKING VOLTS NOT
DETECTED
The cranking voltage has
not been detected.
4.
If the cranking voltage is
normal, press «ENTER» to
begin
charging
system
test.
5.
Press the «ENTER» key,
you will view the following
screen.
6.
Press the «ENTER» key,
one of the three results will be displayed along with the
actual reading measured.
LOW CHARGING VOLTS WHEN TEST AT IDLE
The
alternator
is
not
providing sufficient current
to the battery. Check the
belts
to
ensure
the
alternator is rotating with engine running. If the belts are
slipping or broken, replace the belts and retest. Check
the connections from the alternator to the battery. If the
connection is loose or heavily corroded, clean or
replace the cable and retest. If the belts and
connections are in good condition, replace the
alternator.
PRESS ENTER FOR
CHARGING TEST
MAKE SURE ALL
LOADS ARE OFF
ALT. IDLE VOLTS
××.××V LOW
CRANKING VOLTS
NO DETECTED
