9
RAMP MODE
When the ramp is set to
(ramp yes), the low and slow ramp mode is enabled. This mode is used for slow
cooks so the food never overcooks. This feature will gradually lower the pit temperature to the food setpoint temperature
when the food is within 30 degrees of being done. The controller will hold the pit temperature slightly above the food
setpoint as long as there is fuel.
The factory default setting is
(ramp no), so ramp must be enabled to use it. Note: when using this feature,
the pit temperature can be started higher than normal to reduce cook time and not overcook the food. If the food probe is
not plugged in and the ramp mode is turned on, the ramp LED will be on but no ramping will take place.
BEEPER INTENSITY
The beeper intensity can be adjusted from 0-10. 0 is off, 1 is a small, infrequent chirp and a 10 is a frequent, loud beep.
The factory default is 4. If you have multiple pits, this feature is useful for distinguishing one pit from another, by giving
each one a unique beep duration.
