RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
33
Change Password
From the status menu’s RPC > prompt, type
CONFIG. The following menu appears:
RPC > CONFIG
1) . . . Change Password
2) . . . Change Outlet Name
Enter Request:
Select #1, “Change Password,” and press
<Enter.> The RPC responds:
Enter Current Password:
Since the factory default password is a
carriage return, press <cr>. If this is not an
initial set-up and a password has already
been set, enter the current password,
followed by <cr>. If you enter the password
incorrectly, the RPC responds with an
“Error” message and returns to the main
menu. Consequently, you must start over by
typing “CONFIG” to access the
configuration menu. If you enter the current
password correctly, the RPC responds:
Enter New Password:
Enter a new password (maximum field
length, 8 alphanumeric characters), followed
by <cr>. The RPC responds:
Re-Enter New Password:
Re-enter the new password identically to the
first entry. The password feature is case
sensitive. If you fail to re-enter the new
password correctly, the RPC responds with
an “Error” message and returns to the main
menu. Consequently, you must start over by
Summary of Contents for RPC-2
