A
3
X
Sport
User Manual V1.0
http://www.bay-tec.de 1 / 5 [email protected]
Caution Notes
Thank you for choosing our products. If any difficulties are encountered while setting up or operating it, please
consult this manual first. For further help, please don’t hesitate to contact us via email
.
Before power on, put the aileron, elevator and rudder sticks in the middle position. The controller needs to
perform self-calibration and stick centering after you plugging the battery, the LED will keep blinking Blue
rapidly for about 3 seconds while calibrating, don’t move the plane and the sticks until the initialization is done.
It’s extremely important to verify that the gyro reacts in the correct direction before flight, or it could lead to
losing control or even crash during flight!
You need to restart the controller after changing the receiver type to make new setting take effect.
Never use the delta-wing or V-tail mixing functions of your transmitter.
A3 supports a wide working voltage from 5 to 7.4V, you can use HV receiver or servo directly.
The radio control models are not toys. The propellers rotate at high speed and pose potential risk, please carry
out debugging and flying in open space far away from the crowd. The beginner should be directed by someone
experienced.
About D/R and EXPO
When the gyro is activated, you might see that the range of movement of the servo become much larger than
before when moving the sticks. This is normal but not a problem because a rotation rate set point has been
applied to the outputs by the gyro. The sticks are not only used to control the movement of the surface, but
also the rotation rate of the plane in that axis. Anyway the controller will not change the settings of dual rate or
expo in your transmitter. The settings will always work in any flight mode.
Features
One-click Auto Hover!
4 Flight Modes:
Normal
,
Auto-balance
,
Auto-hover
and
Gyro Off
modes.
3 Wing Types:
Standard
,
Delta-wing (Flying-wing)
and
V-tail
.
3 working frequencies for servos
：
50Hz, 125Hz and 250Hz
；
Separated gain adjustment for each flight mode.
Automatic stick centering.
HV (7.4) operating voltage supported.
Futaba S.Bus / S.Bus 2 supported.
Easy to use, extremely well-suited to beginners.
Specifications
Input Voltage: 5 to 7.4V
Servo Travel: 1520 ± 500μs
Gyroscope. ± 2000dps
Accelerometer. ± 4g
Operating Temp. -40 . ~ 80°C
Size. 43 × 27mm
Weight. 11 g
.
