4 Operating the Salt Relax POWER
13
Intelligent mode
This mode uses the two operating parameters desired water temperature and min. filtration time per day
(min. 2 hours to max. 24 hours). Filtration is activated for at least 10 minutes every two hours in order to
check the water temperature.
The selected minimum filtration time is split up so that spread over the day, filtration is switched on and off
for equal amounts of time. If the desired temperature is not reached within one switch-on time, this switch-on
time is automatically extended. The extra time is subtracted from the following filtration cycles, whereby the
first 10 minutes of each filtration cycle are run in every case.
Desired water temperature. Set using
/
Minimum filtration runtime. Set using
/
.
Using the settings (see left) as an example, the diagram below illustrates how this function works:
Sets the speed of the circulating pump (only when using a circulating pump with variable speed control).
see below
Filter cleaning (available in all operating modes)
This menu is used to facilitate backwashing of the sand filter.
As soon as the menu is activated in one of the filtration modes (Manual, Automatic, Heating, Smart,
Intelligent), the chlorine production cell is switched off.
Now proceed as follows:
- Using the
/
keys, set the filtration pump to Off
- Set the valve of your filtration pump to Backwashing.
- Switch the filtration pump back on again (On). You can follow the expired backwashing time on the counter.
It is imperative to ensure that your filter is adequately backwashed!
- After an appropriate backwashing cycle, switch the filtration pump off and reset the valve to Filtration. If
desired, you can now run a rinse cycle. The process is the same as for backwashing, but the valve is set to
Rinse.
- When
is pressed to exit Filter Cleaning, the system switches back to the programmed mode.
NOTE!
BAYROL recommends that you select the maximum filtration times. Long filtration runtimes ensure high filtering performance of the
sand filter and allow adequate production of the disinfection agent.
If filtration runtimes are too short, this will inevitably cause problems with the disinfection of the water (e.g. algae growth etc.)
