4.0 Installation
8
1
4.1
Initial Preparation
1. Unpack the fire unit from the box. The fire
surround, coal bed and fender assembly are
packed in individual boxes within the main carton
and should be left in these boxes until required.
4.2
Gas Supply
1. The gas installation should be in accordance
with BS6891. The gas supply to the fire is
provided from the service cock on the boiler
using the supply pipe provided in the fire kit. The
pipe is the correct length and will not need
shortening.
4.3
Fitting the Fire
1. Remove the two thread forming screws from
the front corners of the boiler base tray (Fig. 8).
2. Remove the fire surround from its packaging
(Fig. 6).
NOTE:
The surround is easily distorted and
should be handled carefully.
3. Position the fire surround around the fire
combustion box and lower it into position,
ensuring that the top lugs locate onto the top of
the fire combustion box and the bottom lugs
locate into the slots in the sides of the
combustion box (Fig. 7).
4. Position the fire in the fireplace opening and
ensuring that the flue spigot locates into the
downdraught diverter on the boiler, push the fire
back into the opening. Look through the fire to
align the two slots in the flue spigot with the holes
in the boiler hood (Fig. 9).
5. Fit the two screws that locate the fire
combustion box to the boiler base tray (Fig. 10).
6. Fit and tighten the two screws inside the fire
flue spigot (Fig. 9).
7. Fit the fire gas supply pipe (Fig.11).
Fire Gas Supply Pipe
Flue
Spigot
Bottom
Lug
Boiler Hood
Fire Surround
Fire Surround
Fig. 7
Fig. 6
Fig. 8
Fig. 9
Fig. 11
Fig. 10
Fire Surround
