9.0 Changing Components
18
9.1
Changing Components
WARNING:
Isolate the gas and electricity
supplies to the boiler and fire unit before
changing any components.
1. Lift the controls access door away from the
fender assembly (Fig. 42).
2. Turn off the gas supply at the service cock
(Fig. 45).
3. Carefully remove all the loose coals, side
cheeks, rear and front coals (Fig. 43).
CAUTION:
The coals are extremely fragile
and must be handled accordingly. Gloves
should be worn and any inhalation of the dust
should be avoided. Keep the coals away from
children at all times. Never use coals other
than those originally supplied or Genuine Baxi
Spare Parts. Never put additional coals on the
fire. Please read section 1.3 Important
Information.
4. Lift the fender assembly to disengage the
hooks and remove it (Fig. 42).
6. Disconnect the gas supply to the fire at the gas
tap elbow connection (Fig. 44).
NOTE:
After changing any components carry
out checks for gas soundness.
9.2
Burner and Injector
1. Undo the screw holding the burner to the
controls mounting plate, and disengage the
burner inlet from the injector (Fig. 46).
2. Fit the new burner in reverse order.
To change the injector remove the burner as
described above.
3. Using a spanner on both the adaptor barrel
and fire injector, remove the injector from the
barrel (Fig. 47).
4. Fit the new injector.
Retaining
Screw
Burner
Injector
Fender Assembly
Fig. 43
Fig. 42
Gas Tap Elbow
Controls Access Door
Fig. 44
Gas Service Cock
Fig. 45
Fig. 46
Fig. 47
