11.
Locate the spacer frame to the rear of the hotbox
(The foam seal must be to the rear of the spacer
frame and NOT against the flanges of the
hotbox)
. Secure the spacer frame to the hotbox using
the six edge clips supplied. Position these as in
figure 15.
10. HOTBOX INSTALLATION
10.1 Cable retention and floor
fixing.
1.
Make sure that the relevant areas at
the fireplace back or floor are sound
enough to take the eyebolts and
screws. If these areas have
deteriorated due to prolonged use they
should be made sound with a suitable
cement.
2.
Drill four holes in the rear wall of
the fireplace for the fibre plugs. The
holes should be drilled within the
range of positions shown in figure 16
using a no.12 masonry drill. The holes
should be equidistant each side of the
centre line of the fireplace to ensure
that the appliance finishes centrally in
the opening when tension is applied to
the cables.
3.
Insert a fibre plug into each hole.
Use the fibre plugs supplied with this
appliance -
Never use plastic plugs
Page 20
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 16. Eyebolt positions
Figure 15. Fitting the edge clips
