Maintenance
KSG 200 A/KSG 200 TA
50 / 60
822-170-3
11.3 Charging the transmitter battery
CAUTION
Dangerous electric voltage on the charger
Risk of injury due to electric shock.
The charger is an electrical equipment that feeds voltages and currents
that are dangerous for humans.
Only use the supplied charger for KSG 200 A/KSG 200 TA.
Protect the charger against humidity.
Use the charger only in dry spaces.
Note:
At room temperature (approx. 19 – 21 °C), the battery must be charged
every 2
months
. Intervals for higher storage temperatures: Chapter
Storing the system
(on page 55)
If the transmitter battery level is low, the
Battery LOW LED lights up.
The transmitter is
automatically switched off after 10 to 20 minutes.
1. Connect the connection cable of the charger on the transmitter to the
Charger
jack.
2. Connect the charger to the mains voltage.
The charging process starts and is indicated by the LED on the charger.
When the battery is charged fully, the charger automatically changes to the float charge
mode.
Information on the charging currents of the charger is given in the chapter
Charger
(on
page 19).
3. After the transmitter battery is charged, disconnect the charger from the mains and from
the transmitter.
11.4 Charging the receiver
When the receiver charge status is low, the
sign flashes on the receiver display.
To charge the receiver, place it in the transmitter holder.
The cable identification system is moved to the initial state. The receiver is charged.
