Baumer Hubner HMC16 Series, Mounting And Operating Instructions

Page: 30 / 44

SETTINGS HMCP16 / ADjUSTMENT OF THE INTERPOLATION OF THE PULSES (CyCLES)
26/40 MB168T1EN - 11184527, 19A2, Baumer_HMC16-T1_II_EN
y
0 1 2 3
128 256 512 1024 0
x
512 1024 2048 4096 1
2048 4096 8192 16384 2
8192 16384 32768 65536 3
32768 65536 131072 262144
4
= Factory setting
7.3 Adjustment of the interpolation of the pulses (cycles)
Adjustment of the interpolation of the pulses (cycles) of output 1 (pin header 1) and output
2 (pin header 2)�
The output pulses (cycles) can be adjusted via 3 different jumper positions on the corre-
sponding pin header on the electronic board, see section 7.2.1 or section 7.2.2 , to higher
or lower interpolation, depending on ordered output pulses (cycles) for each output, see
also
section 6.2.3
�
Jumper position output pulses (cycles) , marked shows example of section 6.2.3 �