Baumatic FI NC90, Installation, Use And Maintenance Instructions

Page: 24 / 61

9880022202-EN-040715.doc3
24
Built-in measurements
The dimensions of the opening to be made on the cabinet for fitting the oven are
indicated in
figures. Ensure that the cabinet where the oven is to be installed, is able to
support the weight of 30 kg for FI 60; 45 kg. for FI 90 and FI 70; 70 kg for FI TWIN.
For the opening in the cabinet follow the respective dimensions of the type of oven
purchased, indicated in
Fig. 01 for FI 60, Fig. 02 for FI 65, Fig. 03 for FI 70, Fig. 04 for
FI NC90/SC90 and Fig. 05 for FI TWIN.
It is necessary to create an opening in the rear part of the bottom of the cabinet or in the
oven support shelf, (
see figures) , to allow sufficient air to circulate for the cooling of the
oven during functioning. For a good functioning of the gas burners, as well as the rear
opening, a further opening must be made on the kitchen skirting board. The lacking of
this opening can cause the malfunctioning or switch-off of the gas burner
Ensure the oven is safely installed inside the cabinet. Use screws
A for fixing the oven.
OVEN ELECTRICAL CONNECTION
Make sure that the electric current has been removed before connecting the oven to
the electric mains.
Functioning happens in single-phase alternate current 220-230-240 V~ 50-60 Hz, using
flexible cable. Ensure that the household system can support the charge of the appliance.
(see serial plate).
The electric safety of this appliance is only assured if the same is correctly connected to
a system having efficient earth connection, according to the legal Standards in force.
In case of permanent connection to the electric mains, apply a bipolar switch
dimensioned to the corresponding charge, with an opening for every contact of at least 3
mm.
In models where present, the flexible cable is supplied without plug. The plug to be used
must be suitable to the electric charge of the product and must comply with the
Standards in force.
The installer must ascertain that the section of the socket cables is suitable to the power
absorbed by the oven, as indicated in the serial plate.
The connection socket must be easily accessible. Disconnection of the appliance from
the electrical supply must be allowed after installation is made.