o
The water supply to the appliance can also be connected to the
house’s hot water line, or centralised heating system, as long as
the temperature does not exceed 60°C at any time.
o
If the temperature exceeds this limit, the wash cycle length will
be reduced and the efficiency of the appliance will be
dramatically lower.
o
The connection to the hot water line can be made by following
the same procedure as above for the cold water line.
Water outlet
o
Connect the drain hose to the rear of the appliance.
o
Insert the drain hose into the drain pipe with a minimum
diameter of 4 cm. Alternatively you can let it run into the sink as
long as you ensure it is not bent or crimped in the process. You
should use the plastic support that comes with the appliance.
o
If the sink is 1000 mm above the floor, the excess water in the
hose cannot be drained directly into the sink. It will be necessary
to drain the excess water into a bowl or a suitable container that
is held outside and lower than the sink.
IMPORTANT: Do not insert the drain hose too deeply into the
water pipe, as this may cause siphoning.
o
The free end of the hose must be at a height of lower than 75
cm and must not be immersed in water to avoid any back-flow.
35
