TP10583
PAGE 42
K.) Turn flat head screws further into the paper stop assembly.
L.) Manually move the paper stop until the paper stop is in the correct
position as determined in Step #6.H.
M.) Run the flat head screws out of the paper stop assembly until the
heads of the screws come in contact with the lower half pan brace.
See Figure #10.
N.) Tighten the nuts on the flat head screws against the paper stop
assembly.
O.) Re-check that the paper stop is still positioned correctly by making
sure it is at the dimension determined in Step #6.H.
P.) Loosen nuts holding the home position switch to it’s bracket.
Q.) Manually move the paper stop assembly away from home position so
that there is 0.25”(6.35mm) gap between the heads of the home
position screws and the lower half pan brace. A 1/4” allen wrench
may be used to aid in getting the proper distance.
Note: This dimension is critical. The software is programmed so that
the paper stop must travel 0.25”(6.35mm) from the time when the
home position switch is tripped until the paper stop reaches home.
Any variation in this distance may cause the fold lengths to be off.
R.) Move the home position switch so that the paper stop assembly trips
at the position described in Step #5.R and tighten nuts holding
switch.
S.) The deflector pusher will now need to be reset as described in Steps
#2.I - 2.O.
T.) Place pan back into the machine.
U.) Turn power off and back on.
V.) Choose to initialize the folder when prompted to do so by the
Operator Panel Display.
Note: This must be done each time the paper stop’s home position
has been changed in order for proper functioning of the fold pan.
W.) Place the #1 fold pan into deflect and set the #2 fold pan at half of the
sheet length you are running for this calibration procedure.
X.) Run a test sheet to check that the sheet is folded exactly in half. If the
sheet is folded exactly in half, the machine is now ready to run
production. If the sheet is not folded exactly in half, then Steps #6.C
#6.C - 6.X will need to be repeated.
