PAGE 37 TP10583
J.) Manually move the paper stop away from home position enough so
that you may use a 4mm allen wrench in the flat head screws on the
paper stop. These screws will be adjusted to position the paper stop
correctly for the new home position. See Figure #8 on page 37.
K.) Use a 10mm wrench to loosen up the nuts on the flat head screws.
See Figure #8 on page 37.
L.) Turn flat head screws further into the paper stop assembly.
M.) Manually move the paper stop until the paper stop is in the correct
position as determined in Step #5.I.
N.) Run the flat head screws out of the paper stop assembly until the
heads of the screws come in contact with the lower half pan brace.
See Figure #8 on page 37.
O.) Tighten the nuts on the flat head screws against the paper stop
assembly.
P.) Re-check that the paper stop is still positioned correctly by
making sure it is at the dimension determined in Step #5.I.
