EN-16
5 - 9 for driving screws into soft material
10 - 18 for driving screws into soft and hard material
for heavy drilling
7. AUTOMATIC SPINDLE LOCK
The automatic spindle lock allows you to use it as a regular screwdriver. You can give an extra twist
to firmly tighten a screw, loosen a very tight screw or continue working when the battery energy has
expired. For manual screwdriver purposes, the chuck is automatically locked when the tool is off.
8. USING THE LED LIGHT
The sight light allows you to keep a clear view under less illuminated circumstances. To turn on the light
simply press the on/off switch. When you release the on/off switch, the light will be off.
9. DRILLING
When drilling into a hard smooth surface, use a center punch to mark the desired hole location. This will
prevent the drill bit from slipping off center as the hole is started. Hold the tool firmly and place the tip
of the bit at the point to be drilled. Depress the switch trigger to start the tool. Move the drill bit into the
workpiece, applying only enough pressure to keep the bit cutting. Do not force or apply side pressure to
elongate a hole.
Tungsten carbide drill bits should always be used for concrete and masonry. When
drilling in metal, only use HSS drill bits in good condition. Always use a magnetic bit
holder (not included) when using short screwdriver bits. When screw-driving, apply a small
quantity of liquid soap or similar to the screw threads to ease insertion.
10. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the load on the machine immediately and allow
cooling for approx. 30 seconds at the highest no-load speed.
11. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended for the power tool cannot be subject to overload. When the load is too high or
the allowable battery temperature of 75°C is exceeded, the electronic control switches off the power tool
until the temperature is in the optimum temperature range again.
12. PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging by the “Discharging Protection System”. When
the battery is empty, the machine is switched off by means of a protective circuit: The inserted tool no
longer rotates.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of the trigger, is positioned in the lock function.
Unlock the forward/reverse rotation control by putting it into the required rotation position. Push the
trigger and the drill will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS COMPLETELY TIGHTENED. WHY?
Summary of Contents for CDT212W
Page 1: ...ORIGINAL INSTRUCTION MANUAL CDT212W 12V LITHIUM ION DRILL DRIVER ...
Page 10: ...EN 10 1 2 3 4 5 6 7 8 9 ...
Page 11: ...EN 11 A A A A C E A F B D ...
Page 20: ......
