BAUKER CDT212W, Original Instruction Manual

Page: 15 / 20

EN-15
OPERATION
1. ON / OFF SWITCH (SEE C)
Depress the On/Off switch to start and release it to stop your drill. The on/off switch is fitted with a brake
function which stops your chuck immediately when you quickly release the switch.
It is also a variable speed switch that delivers higher speed and torque with increased trigger pressure.
Speed is controlled by the amount of switch trigger depression.
WARNING: Do not operate for long periods at low speed because excess heat
will be produced internally.
2. SWITCH LOCK
The switch trigger can be locked in the OFF position. This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger, place the rotation control in the center position.
3. REVERSIBLE (SEE FIG. C)
For drilling and screw driving use forward rotation marked “ ” (lever is moved to the left). Only use
reverse rotation marked “ ” (lever is moved to the right) to remove screws or release a jammed drill
bit.
Warning: Never change the direction of rotation when the chuck is rotating,
wait until it has stopped!
4. TWO-SPEED GEAR CONTROL (SEE FIG. D)
The drill has a two-speed gear control designed for drilling or driving at LO (mark is 1) or HI (mark is 2)
speeds. A slide switch is located on top of the drill to select either LO or HI speed. When using the drill
in the LO speed range, the speed will decrease and the drill will have greater power and torque. When
using the drill in the HI speed range, the speed will increase and the drill will have less power and torque.
Gear I
Low speed range: for screwdriving or working with large drilling diameter
Gear II
High speed range: for working with small drilling diameter
WARNING: To prevent gear damage, always allow the chuck to come to a
complete stop before changing the direction of rotation or the two-speed gear
control.
5. CHUCK ADJUSTMENT (SEE FIG. E)
To open the chuck jaws rotate the front section of the chuck. Insert the drill bit between the chuck jaws
and rotate the front section in the opposite direction. Ensure the drill bit is in the center of the chuck jaws.
Finally, firmly rotate the front chuck section in the opposite directions. Your drill bit is now clamped in the
chuck.
6. TORQUE ADJUSTMENT (SEE FIG. F)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment ring. The torque is greater when the torque
adjustment ring is set on a higher setting. The torque is less when the torque adjustment ring is set on a
lower setting.
Make the setting as follows:
1 - 4 for driving small screws