Unscrew the top spacer and disconnect the two boards. Next place the three
potentiometers
(B100k)
to their respected places on the top board. Push them well until they
sit absolutely flat on the board
.
Then place the mono
jacks
and the
switch
on the board.
Don’t solder anything yet.
Place the
spacer
back in the opening. Take the
front panel, screw
and mount
it with the board. Check
that all the components came through. Secure the jacks to the panel with the
washers
and the
nuts
(keep in mind not to tighten the jack nuts too much as you may damage the panel!).
Push the
switches
to be sure that they come
through the panel. Make sure that everything is
properly aligned. Now you are finally ready to
solder all these components.
7
